Hi,

I noticed that the displayed quality value does not seem to match the actual output.

When the machine shows 25% quality, only about 2.5% of the products actually get quality.

To get about 25% quality products, I have to increase the module values until the machine displays 250% quality.

So the displayed quality value appears to be 10 times higher than the actual result.

Could you check this?

Thanks.

Ensure that you have reset the next probability for all the quality levels since they have been multiplied by 10. You might still have the old .1 next probability, which should now be 1.

I did a few tests to ensure this was working as intended, and they seemed to show standard results from 25% quality.

12k iron into sticks, got 18k normal back (each produces 2 sticks) with 6k uncommon+
did a longer test with 12k copper and 12k gears to make red science. Since they are 1 of each to make 1 pack, and it was spot on with 9k normal and 3k quality.

So most likely the issue I mentioned is causing you to have 1/10th the return. Make sure you update those default values.

Thanks, that fixed the issue.

I still had the old next probability value set to 0.1. After changing it to 1, the quality output now matches the displayed value.

Thanks for the help!