Hi. When using blueprint mode + belt tallying, the belt tally sometimes improperly identifies output belts/lanes. The most notable case for this is burner miners, especially in Py, where it attempts to label the fuel/ash belt as an output and ends up overlapping the belt tallies at one corner. (Also the fuel/ash belt tallies are just irrelevant due to the fuel of choice being unknowable by the mod but I can ignore them if they aren't getting in the way of the tallies I care about)
Would it be possible for the belt tally system to be updated to only include belts and lanes that drills directly output to?
As a bonus bug, the belt planner also gets kind of confused when there are belt outputs in two directions.
That said - the belt tally otherwise seems very robust for blueprints. I think it actually might not even be 'bugged' so much as have UI issues when belts are close together or pointing in different directions? Because I might just be misreading the tallies.
