Hi, im playing with bobs mods, and when using the tier 1 furnace with bobs steel recipe, it only takes iron plate input from one side of the belt. it only happens once the furnace is completely full of iron plates, meaning that it will work fine as long as the stack limit isnt reached, but when it does it will only pull input from one half of the belt. I tried seeing if it was a loader related issue, but i tried both using yours and deadlocks, and both have the same issue.

I do not think that this is the fault of loaders, belts or stoves. Most likely this behavior will be in a similar situation with other "assembling-machine"

I think I might have an issue with steel recipes in general, tried changing a couple settings and doing some testing, and after switching your setting 'on steel recipe', im getting an error when i try to load the mod. it says: 'steel plate2' does not exist. Source: steel-processing(technology), mods to be disabled: Load-Furn. I tried changing the settings for the mod inside of its file in appdata, and it wont work after changing the on steel recipe setting back. I also tried reinstalling the mod to see if that would fix the issue, but it does not. Even after reinstalling when I try to load the mod i still have the same error show up.

Hello!
My computer broke down and the electronics stores are closed, because of the coronovirus only grocery and pharmacies work. There will be an opportunity I will take a look.