Add circuit interfaces to reach nuclear reactor you build, to output the reactor's current state to the circuit network. The values can also be read by hovering the mouse over the interface itself.
Compatible with Realistic Heat Glow and blueprint friendly!
The interface's status LED provides some basic information about the reactor state:
- Cyan: too cold to produce steam
- Green: capable of producing steam
- Yellow: at maximum temperature
- Red: disabled by circuit signal
To manually add an interface to an existing reactor, place your cursor over it and press the Add/remove reactor interface keyboard shortcut (Control + Shift + I by default).
To remove an interface, press the shortcut again while the mouse is over a reactor or its interface.
Output signals
Current reactor temperature
Percentage of current fuel remaining
- Type and count of cells in the reactor's fuel slot
- Type and count of cells in the reactor's spent fuel slot
Input signals
Pauses the reaction
Sending the Stop reactor signal stops fuel consumption and heat production, while still allowing heat to flow from the reactor
Keyboard controls
- Add/remove reactor interface: defaults to
Control + Shift + I
Mod settings
- Merged interface sprite (startup): Use combined reactor and interface sprite for improved appearance at night and when heated. Disable this setting if you are having graphical issues with reactors added by other mods. Enabled by default.
- Automatically build interfaces (map): A new interface is automatically added to each reactor as it is built. If this mod causes performance issues, disable this setting and manually remove any unnecessary interfaces with the keyboard shortcut. Enabled by default.
Uninstallation
This mod is designed to be as low-impact as possible. Simply removing the mod will remove all interfaces and leave your reactors untouched.